If your digital control valve still cycles properly but your water has turned hard, the problem is often just “dead” resin beads. We can supply the high-quality media needed to re-bed your existing tank, which restores factory-level performance for a fraction of the cost of a full unit. This is a common maintenance step for systems that are 8 to 12 years old but still structurally sound.

However, you must inspect the outer shell of your fiberglass tank before deciding. In Paradise Valley, extreme garage temperatures can make older plastic liners brittle over time. If you notice fiberglass fibers showing on the tank exterior or any salt crusting near the base, a full system replacement is the only safe way to prevent a catastrophic burst and a major flood in your home.

High garage temperatures often cause moisture to evaporate and re-condense inside your brine tank, creating a solid rock crust known as a salt bridge. This bridge prevents the salt from reaching the water, which means the system regenerates with plain water instead of brine. We recommend keeping your salt level no higher than halfway and breaking up any hard crust with a broom handle once a month.

It is also vital to clean the bottom of your brine tank every two years to remove accumulated salt sludge. This debris consists of dirt and impurities from the salt that can eventually clog the small internal injectors in your control valve. Using high-purity salt pellets and keeping the tank free of mud ensures your hardware works efficiently and extends the overall life of your water system.